EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767297071	101 Count	473 Count
1767295270	100 Count	472 Count
1767293469	99 Count	469 Count
1767291669	98 Count	463 Count
1767289868	97 Count	459 Count
1767288067	96 Count	455 Count
1767286267	95 Count	452 Count
1767284466	94 Count	445 Count
1767282665	93 Count	442 Count
1767280864	92 Count	439 Count
1767279072	91 Count	436 Count
1767277271	90 Count	431 Count
1767275470	89 Count	427 Count
1767273670	88 Count	422 Count
1767271869	87 Count	418 Count
1767270068	86 Count	413 Count
1767268268	85 Count	409 Count
1767266467	84 Count	404 Count
1767264666	83 Count	399 Count
1767262866	82 Count	392 Count
1767261065	81 Count	388 Count
1767259264	80 Count	383 Count
1767257471	79 Count	380 Count
1767255671	78 Count	374 Count
1767253870	77 Count	370 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)