EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1762096411	77 Count	907 Count
1762094611	76 Count	889 Count
1762092810	75 Count	845 Count
1762091009	74 Count	830 Count
1762089209	73 Count	796 Count
1762087408	72 Count	777 Count
1762085607	71 Count	751 Count
1762083806	70 Count	742 Count
1762082006	69 Count	737 Count
1762080205	68 Count	733 Count
1762078404	67 Count	731 Count
1762076611	66 Count	728 Count
1762074811	65 Count	722 Count
1762073010	64 Count	713 Count
1762071209	63 Count	697 Count
1762069409	62 Count	687 Count
1762067608	61 Count	676 Count
1762065807	60 Count	665 Count
1762064007	59 Count	657 Count
1762062206	58 Count	655 Count
1762060405	57 Count	643 Count
1762058604	56 Count	640 Count
1762056803	55 Count	635 Count
1762055011	54 Count	630 Count
1762053210	53 Count	625 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)