EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9WKL-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9WKL-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773171654	35 Count	180 Count
1773169853	34 Count	176 Count
1773168052	33 Count	170 Count
1773166252	32 Count	166 Count
1773164451	31 Count	159 Count
1773162650	30 Count	157 Count
1773160849	29 Count	151 Count
1773159049	28 Count	148 Count
1773157248	27 Count	142 Count
1773155455	26 Count	139 Count
1773153654	25 Count	132 Count
1773151853	24 Count	127 Count
1773150053	23 Count	121 Count
1773148252	22 Count	116 Count
1773146451	21 Count	108 Count
1773144651	20 Count	103 Count
1773142850	19 Count	97 Count
1773141049	18 Count	93 Count
1773139249	17 Count	87 Count
1773137448	16 Count	80 Count
1773135647	15 Count	75 Count
1773132008	14 Count	75 Count
1773129004	13 Count	75 Count
1773127646	12 Count	75 Count
1773125438	11 Count	75 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)