EA2RCF LoRa APRS MAP

My position About Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1746475011	210 Count	517 Count	160 Count
1746474111	209 Count	515 Count	160 Count
1746473210	204 Count	481 Count	156 Count
1746472309	194 Count	450 Count	147 Count
1746471409	189 Count	441 Count	143 Count
1746470508	187 Count	426 Count	142 Count
1746469669	178 Count	413 Count	138 Count
1746468768	171 Count	391 Count	132 Count
1746467868	163 Count	377 Count	125 Count
1746466967	158 Count	365 Count	121 Count
1746466066	149 Count	350 Count	113 Count
1746465166	137 Count	328 Count	102 Count
1746464265	133 Count	323 Count	99 Count
1746463364	130 Count	321 Count	97 Count
1746462464	128 Count	319 Count	96 Count
1746461563	120 Count	308 Count	89 Count
1746460662	118 Count	307 Count	88 Count
1746459762	117 Count	307 Count	88 Count
1746458861	115 Count	305 Count	87 Count
1746457960	113 Count	299 Count	86 Count
1746457060	112 Count	298 Count	86 Count
1746456159	110 Count	296 Count	85 Count
1746455258	106 Count	292 Count	82 Count
1746454358	102 Count	288 Count	79 Count
1746453457	101 Count	286 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)