EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1765076233	850 Count	268 Count	107 Count
1765075333	843 Count	267 Count	107 Count
1765074432	837 Count	266 Count	107 Count
1765073531	831 Count	265 Count	107 Count
1765072649	825 Count	264 Count	107 Count
1765071748	820 Count	263 Count	107 Count
1765070846	812 Count	262 Count	107 Count
1765069946	806 Count	261 Count	106 Count
1765069045	800 Count	260 Count	106 Count
1765068144	794 Count	259 Count	106 Count
1765067243	786 Count	258 Count	106 Count
1765066343	781 Count	258 Count	106 Count
1765065442	774 Count	254 Count	106 Count
1765064541	768 Count	254 Count	106 Count
1765063640	761 Count	254 Count	106 Count
1765062739	755 Count	254 Count	106 Count
1765061839	747 Count	253 Count	105 Count
1765060938	742 Count	253 Count	105 Count
1765060037	735 Count	253 Count	105 Count
1765059137	728 Count	253 Count	105 Count
1765058236	722 Count	253 Count	105 Count
1765057335	715 Count	252 Count	104 Count
1765056434	708 Count	252 Count	104 Count
1765055534	703 Count	251 Count	104 Count
1765054633	695 Count	250 Count	104 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)