EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP7TWA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP7TWA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1764005438	123 Count	188 Count
1764004537	122 Count	188 Count
1764003637	121 Count	187 Count
1764002736	120 Count	184 Count
1764001835	119 Count	183 Count
1764000934	118 Count	181 Count
1764000034	117 Count	180 Count
1763999133	116 Count	178 Count
1763998250	115 Count	176 Count
1763997350	114 Count	174 Count
1763996449	113 Count	173 Count
1763995548	112 Count	170 Count
1763994647	111 Count	168 Count
1763993745	110 Count	166 Count
1763992846	109 Count	165 Count
1763991945	108 Count	163 Count
1763991044	107 Count	162 Count
1763990144	106 Count	159 Count
1763989243	105 Count	158 Count
1763988342	104 Count	155 Count
1763987442	103 Count	154 Count
1763986541	102 Count	151 Count
1763985638	101 Count	150 Count
1763984738	100 Count	148 Count
1763983837	99 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)