EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IW9GTR-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IW9GTR-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1752557752	324 Count	435 Count	266 Count
1752556848	316 Count	425 Count	259 Count
1752555945	310 Count	412 Count	254 Count
1752555041	302 Count	404 Count	247 Count
1752554137	297 Count	398 Count	243 Count
1752553233	289 Count	390 Count	236 Count
1752552329	282 Count	382 Count	230 Count
1752551425	275 Count	375 Count	224 Count
1752550522	268 Count	368 Count	218 Count
1752550233	267 Count	368 Count	218 Count
1752549329	261 Count	360 Count	213 Count
1752548429	255 Count	352 Count	208 Count
1752547522	247 Count	345 Count	201 Count
1752546618	239 Count	337 Count	194 Count
1752545715	231 Count	329 Count	187 Count
1752544811	224 Count	323 Count	181 Count
1752543908	215 Count	314 Count	173 Count
1752543004	208 Count	307 Count	167 Count
1752542101	200 Count	299 Count	160 Count
1752541197	192 Count	289 Count	153 Count
1752540294	184 Count	281 Count	146 Count
1752539390	177 Count	274 Count	140 Count
1752538487	168 Count	263 Count	132 Count
1752537582	160 Count	255 Count	125 Count
1752536678	151 Count	244 Count	117 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)