EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785071694	544 Count	327 Count	170 Count
1785069767	541 Count	326 Count	169 Count
1785067840	538 Count	325 Count	168 Count
1785065914	536 Count	325 Count	168 Count
1785063987	534 Count	325 Count	168 Count
1785062060	531 Count	324 Count	167 Count
1785060134	529 Count	324 Count	167 Count
1785058207	527 Count	324 Count	167 Count
1785057801	526 Count	324 Count	167 Count
1785055874	524 Count	324 Count	167 Count
1785053947	522 Count	323 Count	167 Count
1785052020	520 Count	323 Count	167 Count
1785050094	518 Count	323 Count	167 Count
1785048167	515 Count	322 Count	166 Count
1785046240	511 Count	320 Count	164 Count
1785044313	509 Count	320 Count	164 Count
1785042387	507 Count	319 Count	164 Count
1785040460	505 Count	318 Count	164 Count
1785038533	503 Count	317 Count	164 Count
1785036606	501 Count	317 Count	164 Count
1785036200	500 Count	317 Count	164 Count
1785034273	497 Count	315 Count	163 Count
1785032346	494 Count	313 Count	162 Count
1785030419	492 Count	313 Count	162 Count
1785028493	489 Count	312 Count	161 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)