EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OK2PYA-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK2PYA-5. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1757891097	410 Count	42 Count	24 Count
1757889170	408 Count	42 Count	24 Count
1757887243	406 Count	42 Count	24 Count
1757885316	404 Count	42 Count	24 Count
1757884910	403 Count	42 Count	24 Count
1757882983	401 Count	42 Count	24 Count
1757881057	399 Count	42 Count	24 Count
1757879130	397 Count	42 Count	24 Count
1757877203	395 Count	42 Count	24 Count
1757875276	393 Count	42 Count	24 Count
1757873350	391 Count	42 Count	24 Count
1757871423	389 Count	42 Count	24 Count
1757869496	387 Count	42 Count	24 Count
1757867570	385 Count	42 Count	24 Count
1757865643	382 Count	41 Count	23 Count
1757863716	380 Count	41 Count	23 Count
1757863310	379 Count	41 Count	23 Count
1757861383	377 Count	41 Count	23 Count
1757859456	375 Count	41 Count	23 Count
1757857530	373 Count	41 Count	23 Count
1757855603	371 Count	41 Count	23 Count
1757853676	369 Count	41 Count	23 Count
1757851749	367 Count	41 Count	23 Count
1757849823	365 Count	41 Count	23 Count
1757847896	363 Count	41 Count	23 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)