EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1752031827	214 Count	141 Count	140 Count
1752030026	213 Count	141 Count	140 Count
1752028234	212 Count	141 Count	140 Count
1752026434	211 Count	141 Count	140 Count
1752024633	210 Count	141 Count	140 Count
1752022832	209 Count	141 Count	140 Count
1752021031	208 Count	141 Count	140 Count
1752019230	207 Count	141 Count	140 Count
1752017430	206 Count	141 Count	140 Count
1752015629	205 Count	141 Count	140 Count
1752013828	204 Count	141 Count	140 Count
1752012027	203 Count	141 Count	140 Count
1752010226	202 Count	141 Count	140 Count
1752008426	201 Count	141 Count	140 Count
1752006634	200 Count	141 Count	140 Count
1752004833	199 Count	141 Count	140 Count
1752003032	198 Count	141 Count	140 Count
1752001231	197 Count	141 Count	140 Count
1751999431	196 Count	141 Count	140 Count
1751997630	195 Count	141 Count	140 Count
1751995829	194 Count	141 Count	140 Count
1751994028	189 Count	137 Count	136 Count
1751992227	174 Count	123 Count	122 Count
1751990427	171 Count	121 Count	120 Count
1751988626	170 Count	121 Count	120 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)