EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1773150951	84 Count	583 Count	6 Count
1773149151	83 Count	572 Count	6 Count
1773147351	82 Count	559 Count	6 Count
1773145550	81 Count	549 Count	6 Count
1773143750	80 Count	535 Count	6 Count
1773141956	75 Count	522 Count	6 Count
1773140154	74 Count	514 Count	6 Count
1773138354	73 Count	507 Count	6 Count
1773136552	72 Count	494 Count	6 Count
1773134753	71 Count	485 Count	6 Count
1773132951	70 Count	473 Count	6 Count
1773129351	68 Count	451 Count	6 Count
1773127550	67 Count	441 Count	6 Count
1773125750	66 Count	429 Count	6 Count
1773123948	65 Count	420 Count	6 Count
1773120355	59 Count	420 Count	6 Count
1773118552	58 Count	420 Count	6 Count
1773116754	57 Count	420 Count	6 Count
1773114951	56 Count	420 Count	6 Count
1773113153	55 Count	420 Count	6 Count
1773111350	54 Count	420 Count	6 Count
1773109551	52 Count	416 Count	5 Count
1773107751	51 Count	415 Count	5 Count
1773105950	49 Count	413 Count	4 Count
1773104150	48 Count	412 Count	4 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)