EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1767309048	48 Count	236 Count
1767307248	47 Count	228 Count
1767305446	46 Count	225 Count
1767303647	45 Count	222 Count
1767300051	39 Count	216 Count
1767298251	38 Count	207 Count
1767296450	37 Count	195 Count
1767294650	36 Count	190 Count
1767292850	35 Count	189 Count
1767291049	34 Count	185 Count
1767289248	33 Count	178 Count
1767287447	32 Count	172 Count
1767285647	31 Count	164 Count
1767283845	30 Count	161 Count
1767282046	29 Count	158 Count
1767280244	28 Count	156 Count
1767278451	23 Count	156 Count
1767276650	22 Count	155 Count
1767274850	21 Count	152 Count
1767271249	19 Count	149 Count
1767269448	18 Count	149 Count
1767267647	17 Count	147 Count
1767265847	16 Count	145 Count
1767264046	15 Count	145 Count
1767262244	14 Count	141 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)