EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2GSM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GSM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1772070899	89 Count	737 Count
1772069099	88 Count	703 Count
1772067297	87 Count	670 Count
1772065498	86 Count	647 Count
1772063696	85 Count	620 Count
1772061902	80 Count	586 Count
1772060102	79 Count	557 Count
1772058300	78 Count	524 Count
1772056501	77 Count	495 Count
1772054700	76 Count	468 Count
1772052899	75 Count	440 Count
1772051099	74 Count	411 Count
1772049298	73 Count	380 Count
1772047498	72 Count	347 Count
1772045697	71 Count	318 Count
1772042095	69 Count	295 Count
1772036699	62 Count	293 Count
1772020494	53 Count	275 Count
1772015098	46 Count	261 Count
1772011497	44 Count	247 Count
1772009698	43 Count	239 Count
1772002494	39 Count	218 Count
1772000695	38 Count	214 Count
1771998893	37 Count	191 Count
1771997098	32 Count	168 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)