EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IK2XR0-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK2XR0-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1751637054	323 Count	318 Count
1751636150	322 Count	317 Count
1751635883	321 Count	317 Count
1751635446	320 Count	317 Count
1751633638	318 Count	315 Count
1751631829	316 Count	313 Count
1751630021	314 Count	311 Count
1751628212	312 Count	309 Count
1751626404	310 Count	307 Count
1751624595	308 Count	305 Count
1751622787	306 Count	304 Count
1751620978	304 Count	302 Count
1751619170	302 Count	300 Count
1751617362	300 Count	298 Count
1751615553	298 Count	296 Count
1751613745	296 Count	289 Count
1751611936	294 Count	284 Count
1751610128	292 Count	275 Count
1751608319	290 Count	273 Count
1751606511	288 Count	271 Count
1751604702	286 Count	269 Count
1751602894	284 Count	267 Count
1751601086	282 Count	265 Count
1751599277	280 Count	263 Count
1751597469	278 Count	261 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)