EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789244560	453 Count	595 Count	131 Count
1789243959	452 Count	594 Count	131 Count
1789243358	451 Count	593 Count	131 Count
1789242757	450 Count	592 Count	131 Count
1789242156	449 Count	591 Count	131 Count
1789241555	448 Count	590 Count	131 Count
1789240955	447 Count	589 Count	131 Count
1789240354	446 Count	588 Count	131 Count
1789239753	445 Count	587 Count	131 Count
1789239152	444 Count	586 Count	131 Count
1789238551	443 Count	585 Count	131 Count
1789237950	442 Count	584 Count	131 Count
1789237350	441 Count	583 Count	131 Count
1789236749	439 Count	576 Count	130 Count
1789236178	433 Count	574 Count	129 Count
1789235578	432 Count	573 Count	129 Count
1789234977	430 Count	571 Count	128 Count
1789234376	428 Count	570 Count	127 Count
1789233775	427 Count	569 Count	127 Count
1789233174	425 Count	567 Count	126 Count
1789232573	423 Count	565 Count	125 Count
1789231972	422 Count	564 Count	125 Count
1789231372	420 Count	562 Count	124 Count
1789230771	418 Count	560 Count	123 Count
1789230170	417 Count	559 Count	123 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)