EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1781192846	482 Count	429 Count	84 Count
1781192246	480 Count	427 Count	83 Count
1781191645	463 Count	411 Count	67 Count
1781191045	452 Count	401 Count	57 Count
1781190443	451 Count	401 Count	57 Count
1781189842	450 Count	401 Count	57 Count
1781189242	449 Count	401 Count	57 Count
1781188640	448 Count	401 Count	57 Count
1781188040	447 Count	400 Count	57 Count
1781187439	446 Count	399 Count	57 Count
1781186838	445 Count	399 Count	57 Count
1781186237	444 Count	398 Count	57 Count
1781185636	443 Count	398 Count	57 Count
1781185035	442 Count	397 Count	57 Count
1781184434	441 Count	396 Count	57 Count
1781183833	440 Count	396 Count	57 Count
1781183233	439 Count	395 Count	57 Count
1781182632	438 Count	395 Count	57 Count
1781182031	437 Count	394 Count	57 Count
1781181430	436 Count	393 Count	57 Count
1781180829	435 Count	393 Count	57 Count
1781180228	434 Count	393 Count	57 Count
1781179627	433 Count	393 Count	57 Count
1781179026	432 Count	393 Count	57 Count
1781178425	431 Count	392 Count	57 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)