EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

M0IGA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0IGA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1789123649	969	920	589	412	7
1789123493	962	920	589	411	7
1789123433	959	920	589	406	7
1789123372	958	920	589	409	7
1789123312	956	919	588	416	7
1789123251	955	919	588	407	7
1789123190	952	919	588	409	7
1789123130	950	918	587	419	7
1789123069	949	918	587	410	7
1789123009	947	917	586	416	7
1789122948	944	917	586	413	7
1789122887	943	917	586	410	7
1789122827	941	916	585	419	7
1789122766	940	916	585	415	7
1789122705	936	915	584	417	7
1789122645	935	915	584	417	7
1789122584	934	915	584	409	7
1789122523	932	914	583	418	7
1789122462	928	912	582	411	7
1789122402	926	911	581	408	7
1789122341	925	911	581	408	7
1789122280	924	911	581	406	7
1789122220	920	910	580	408	7
1789122159	919	910	580	417	7
1789122099	918	910	580	410	7

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)