EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1751638478	895 Count	412 Count	52 Count
1751637877	894 Count	412 Count	52 Count
1751637276	893 Count	412 Count	52 Count
1751636675	892 Count	412 Count	52 Count
1751636075	891 Count	412 Count	52 Count
1751635474	890 Count	412 Count	52 Count
1751634873	889 Count	412 Count	52 Count
1751634272	888 Count	412 Count	52 Count
1751633671	887 Count	412 Count	52 Count
1751633070	886 Count	412 Count	52 Count
1751632469	885 Count	412 Count	52 Count
1751631868	884 Count	412 Count	52 Count
1751631267	883 Count	412 Count	52 Count
1751630666	882 Count	412 Count	52 Count
1751630065	881 Count	412 Count	52 Count
1751629464	880 Count	412 Count	52 Count
1751628863	879 Count	412 Count	52 Count
1751628262	878 Count	412 Count	52 Count
1751627661	877 Count	412 Count	52 Count
1751627060	876 Count	412 Count	52 Count
1751626459	875 Count	412 Count	52 Count
1751625859	874 Count	412 Count	52 Count
1751625258	873 Count	412 Count	52 Count
1751624657	872 Count	412 Count	52 Count
1751624056	871 Count	412 Count	52 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)