EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR7NSI-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7NSI-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1772099123	915 Count	703 Count	385 Count
1772098522	914 Count	679 Count	385 Count
1772097921	913 Count	664 Count	385 Count
1772097321	912 Count	654 Count	385 Count
1772096720	911 Count	649 Count	385 Count
1772096119	910 Count	638 Count	385 Count
1772095518	908 Count	634 Count	384 Count
1772094916	888 Count	613 Count	365 Count
1772094315	878 Count	604 Count	356 Count
1772093714	877 Count	604 Count	356 Count
1772093114	876 Count	604 Count	356 Count
1772092513	875 Count	604 Count	356 Count
1772091912	874 Count	604 Count	356 Count
1772091311	873 Count	604 Count	356 Count
1772090710	865 Count	597 Count	349 Count
1772090109	863 Count	596 Count	348 Count
1772089508	862 Count	596 Count	348 Count
1772088908	861 Count	596 Count	348 Count
1772088307	860 Count	596 Count	348 Count
1772087706	859 Count	596 Count	348 Count
1772087105	851 Count	589 Count	341 Count
1772086504	848 Count	587 Count	339 Count
1772085903	847 Count	587 Count	339 Count
1772085302	846 Count	587 Count	339 Count
1772084701	845 Count	587 Count	339 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)