EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

GW3ATZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GW3ATZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1757890614	220 Count	617 Count	186 Count
1757887006	207 Count	582 Count	175 Count
1757883397	194 Count	549 Count	164 Count
1757879788	180 Count	513 Count	152 Count
1757876179	166 Count	479 Count	140 Count
1757872622	153 Count	432 Count	129 Count
1757869013	142 Count	399 Count	120 Count
1757865404	132 Count	375 Count	112 Count
1757861795	119 Count	352 Count	101 Count
1757858186	109 Count	319 Count	93 Count
1757854577	96 Count	292 Count	82 Count
1757853130	90 Count	276 Count	77 Count
1757849522	77 Count	239 Count	66 Count
1757845912	63 Count	201 Count	54 Count
1757842918	50 Count	167 Count	43 Count
1757840199	40 Count	133 Count	35 Count
1757836590	26 Count	80 Count	23 Count
1757832981	12 Count	45 Count	11 Count
1757829421	428 Count	1006 Count	372 Count
1757825812	414 Count	969 Count	360 Count
1757822204	402 Count	927 Count	350 Count
1757818595	388 Count	888 Count	338 Count
1757814986	374 Count	850 Count	326 Count
1757811377	360 Count	814 Count	314 Count
1757807822	346 Count	783 Count	302 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)