EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

GW3ATZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GW3ATZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1756550291	360 Count	923 Count	292 Count
1756546683	314 Count	845 Count	248 Count
1756543074	303 Count	798 Count	239 Count
1756539465	278 Count	754 Count	216 Count
1756535855	268 Count	725 Count	208 Count
1756532247	258 Count	695 Count	200 Count
1756528690	248 Count	669 Count	192 Count
1756525081	238 Count	640 Count	184 Count
1756521472	228 Count	613 Count	176 Count
1756517863	218 Count	586 Count	168 Count
1756514254	208 Count	560 Count	160 Count
1756510645	198 Count	536 Count	152 Count
1756485489	132 Count	366 Count	100 Count
1756481880	125 Count	338 Count	95 Count
1756478272	116 Count	308 Count	88 Count
1756474663	107 Count	289 Count	81 Count
1756471054	99 Count	271 Count	75 Count
1756467446	71 Count	218 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)