EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1751640187	128 Count	302 Count
1751639887	127 Count	299 Count
1751639586	126 Count	297 Count
1751639286	125 Count	296 Count
1751638985	124 Count	293 Count
1751638684	123 Count	291 Count
1751638384	122 Count	290 Count
1751638083	121 Count	286 Count
1751637782	120 Count	284 Count
1751637482	119 Count	282 Count
1751637181	118 Count	279 Count
1751636881	117 Count	277 Count
1751636580	116 Count	276 Count
1751636280	115 Count	272 Count
1751635979	114 Count	270 Count
1751635678	113 Count	269 Count
1751635378	112 Count	255 Count
1751635077	111 Count	253 Count
1751634777	110 Count	252 Count
1751634476	109 Count	251 Count
1751634176	108 Count	249 Count
1751633875	107 Count	247 Count
1751633574	106 Count	243 Count
1751633274	105 Count	241 Count
1751632973	104 Count	240 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)