EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PE1PNX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PE1PNX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1761901561	376 Count	755 Count	86 Count
1761899757	375 Count	752 Count	86 Count
1761897954	374 Count	749 Count	86 Count
1761896150	373 Count	745 Count	86 Count
1761894346	372 Count	742 Count	86 Count
1761892543	371 Count	738 Count	86 Count
1761890739	370 Count	735 Count	86 Count
1761888935	369 Count	728 Count	86 Count
1761887173	364 Count	727 Count	86 Count
1761885369	363 Count	726 Count	86 Count
1761883566	362 Count	725 Count	86 Count
1761881762	361 Count	724 Count	86 Count
1761879958	360 Count	721 Count	86 Count
1761878155	359 Count	720 Count	86 Count
1761876351	358 Count	719 Count	86 Count
1761874547	357 Count	719 Count	86 Count
1761872744	356 Count	718 Count	86 Count
1761870940	355 Count	718 Count	86 Count
1761869136	354 Count	717 Count	86 Count
1761867333	353 Count	715 Count	86 Count
1761865570	348 Count	711 Count	86 Count
1761863767	347 Count	708 Count	86 Count
1761861963	346 Count	704 Count	86 Count
1761860159	345 Count	701 Count	86 Count
1761858356	344 Count	696 Count	86 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)