EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6ICO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6ICO-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1792895442	880 Count	602 Count	602 Count
1792891841	874 Count	598 Count	598 Count
1792890040	871 Count	596 Count	596 Count
1792888239	868 Count	594 Count	594 Count
1792886439	865 Count	592 Count	592 Count
1792884646	862 Count	590 Count	590 Count
1792882845	859 Count	588 Count	588 Count
1792881045	856 Count	586 Count	586 Count
1792879244	853 Count	584 Count	584 Count
1792877443	850 Count	582 Count	582 Count
1792875643	847 Count	580 Count	580 Count
1792873841	844 Count	578 Count	578 Count
1792872041	841 Count	576 Count	576 Count
1792870240	838 Count	574 Count	574 Count
1792868439	835 Count	572 Count	572 Count
1792866639	832 Count	570 Count	570 Count
1792864838	829 Count	568 Count	568 Count
1792863049	826 Count	566 Count	566 Count
1792861248	823 Count	564 Count	564 Count
1792859448	820 Count	562 Count	562 Count
1792857647	817 Count	560 Count	560 Count
1792855846	814 Count	558 Count	558 Count
1792854046	811 Count	556 Count	556 Count
1792852245	808 Count	554 Count	554 Count
1792850444	805 Count	552 Count	552 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)