EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1779044770	282 Count	732 Count	188 Count
1779043864	279 Count	726 Count	186 Count
1779042959	276 Count	718 Count	184 Count
1779042053	273 Count	713 Count	182 Count
1779041148	270 Count	704 Count	180 Count
1779040242	267 Count	697 Count	178 Count
1779039337	264 Count	689 Count	176 Count
1779038431	261 Count	683 Count	174 Count
1779037526	258 Count	676 Count	172 Count
1779036620	255 Count	672 Count	170 Count
1779035715	252 Count	664 Count	168 Count
1779034809	249 Count	658 Count	166 Count
1779033904	246 Count	651 Count	164 Count
1779032998	243 Count	647 Count	162 Count
1779032093	240 Count	640 Count	160 Count
1779031188	237 Count	634 Count	158 Count
1779030410	234 Count	625 Count	156 Count
1779029505	231 Count	620 Count	154 Count
1779028599	228 Count	611 Count	152 Count
1779027694	225 Count	605 Count	150 Count
1779026788	222 Count	596 Count	148 Count
1779025882	219 Count	590 Count	146 Count
1779024977	216 Count	580 Count	144 Count
1779024071	213 Count	573 Count	142 Count
1779023166	210 Count	565 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)