EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

UN1GWA-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object UN1GWA-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761493058	113 Count	290 Count	76 Count
1761492153	110 Count	284 Count	74 Count
1761491247	107 Count	279 Count	72 Count
1761490342	104 Count	272 Count	70 Count
1761489436	101 Count	265 Count	68 Count
1761488531	98 Count	258 Count	66 Count
1761487626	95 Count	251 Count	64 Count
1761486720	92 Count	246 Count	62 Count
1761485814	89 Count	241 Count	60 Count
1761484909	86 Count	235 Count	58 Count
1761484004	83 Count	230 Count	56 Count
1761483098	80 Count	221 Count	54 Count
1761482193	77 Count	214 Count	52 Count
1761481287	74 Count	210 Count	50 Count
1761480382	71 Count	201 Count	48 Count
1761479476	68 Count	188 Count	46 Count
1761478571	65 Count	179 Count	44 Count
1761477665	62 Count	169 Count	42 Count
1761476760	59 Count	156 Count	40 Count
1761475854	56 Count	144 Count	38 Count
1761474949	53 Count	136 Count	36 Count
1761474178	50 Count	126 Count	34 Count
1761473273	47 Count	114 Count	32 Count
1761472367	44 Count	103 Count	30 Count
1761471462	41 Count	91 Count	28 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)