EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1773207687	112 Count	465 Count
1773204084	111 Count	463 Count
1773200481	110 Count	461 Count
1773196897	109 Count	459 Count
1773193294	108 Count	452 Count
1773189691	107 Count	450 Count
1773186088	106 Count	448 Count
1773182485	105 Count	446 Count
1773178882	104 Count	444 Count
1773175298	103 Count	442 Count
1773171695	102 Count	435 Count
1773168092	101 Count	433 Count
1773164490	100 Count	431 Count
1773160887	99 Count	429 Count
1773157284	98 Count	427 Count
1773153700	97 Count	424 Count
1773150097	96 Count	417 Count
1773146494	95 Count	415 Count
1773142891	94 Count	412 Count
1773139288	93 Count	410 Count
1773135685	92 Count	408 Count
1773132093	91 Count	406 Count
1773128490	90 Count	399 Count
1773124887	89 Count	397 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)