EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1761901061	3 Count	58 Count
1761899715	2 Count	58 Count
1761896113	1 Count	46 Count
1761892510	0 Count	39 Count
1761888907	205 Count	1002 Count
1761885304	204 Count	992 Count
1761881701	203 Count	983 Count
1761878121	202 Count	973 Count
1761874519	201 Count	963 Count
1761870916	200 Count	950 Count
1761867313	199 Count	939 Count
1761863710	198 Count	926 Count
1761860107	197 Count	916 Count
1761856514	196 Count	911 Count
1761852911	195 Count	903 Count
1761849308	194 Count	892 Count
1761845705	193 Count	881 Count
1761842102	192 Count	870 Count
1761838500	191 Count	863 Count
1761834913	190 Count	841 Count
1761831310	189 Count	836 Count
1761827707	188 Count	792 Count
1761824104	187 Count	765 Count
1761820501	186 Count	735 Count
1761816898	185 Count	729 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)