EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789240115	273 Count	312 Count	196 Count
1789239211	271 Count	310 Count	195 Count
1789238307	269 Count	309 Count	194 Count
1789237403	267 Count	308 Count	193 Count
1789236500	265 Count	307 Count	192 Count
1789235596	263 Count	306 Count	191 Count
1789234692	261 Count	305 Count	190 Count
1789233788	259 Count	304 Count	189 Count
1789232885	257 Count	303 Count	188 Count
1789231981	255 Count	301 Count	187 Count
1789231077	253 Count	300 Count	186 Count
1789230173	251 Count	299 Count	185 Count
1789229270	249 Count	297 Count	184 Count
1789228366	247 Count	296 Count	183 Count
1789227462	245 Count	295 Count	182 Count
1789226558	243 Count	293 Count	181 Count
1789225654	241 Count	292 Count	180 Count
1789224751	239 Count	290 Count	179 Count
1789223847	237 Count	288 Count	178 Count
1789223036	235 Count	287 Count	177 Count
1789221229	231 Count	283 Count	175 Count
1789220325	229 Count	282 Count	174 Count
1789219421	227 Count	281 Count	173 Count
1789218517	225 Count	280 Count	172 Count
1789217614	223 Count	279 Count	171 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)