EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1794464557	844 Count	648 Count	495 Count
1794463652	842 Count	646 Count	494 Count
1794462749	839 Count	643 Count	492 Count
1794461845	837 Count	641 Count	491 Count
1794460941	830 Count	622 Count	485 Count
1794460037	828 Count	620 Count	484 Count
1794459134	826 Count	618 Count	483 Count
1794458230	824 Count	617 Count	482 Count
1794457326	822 Count	615 Count	481 Count
1794456422	820 Count	613 Count	480 Count
1794453801	814 Count	608 Count	477 Count
1794452898	812 Count	603 Count	476 Count
1794451994	810 Count	601 Count	475 Count
1794451090	808 Count	599 Count	474 Count
1794450186	806 Count	597 Count	473 Count
1794449282	804 Count	595 Count	472 Count
1794448379	802 Count	593 Count	471 Count
1794447475	800 Count	592 Count	470 Count
1794446571	798 Count	590 Count	469 Count
1794445668	796 Count	589 Count	468 Count
1794444764	794 Count	587 Count	467 Count
1794443860	792 Count	572 Count	466 Count
1794442956	790 Count	565 Count	465 Count
1794442052	788 Count	564 Count	464 Count
1794441148	786 Count	563 Count	463 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)