EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757886554	600 Count	678 Count	447 Count
1757885739	597 Count	674 Count	445 Count
1757884836	594 Count	671 Count	443 Count
1757883932	591 Count	667 Count	441 Count
1757883028	588 Count	664 Count	439 Count
1757882124	585 Count	660 Count	437 Count
1757881221	582 Count	655 Count	435 Count
1757880317	579 Count	651 Count	433 Count
1757879413	576 Count	648 Count	431 Count
1757878510	573 Count	644 Count	429 Count
1757877606	569 Count	638 Count	426 Count
1757876702	565 Count	632 Count	423 Count
1757875799	553 Count	620 Count	412 Count
1757874895	539 Count	607 Count	399 Count
1757873991	536 Count	603 Count	397 Count
1757873087	533 Count	599 Count	395 Count
1757872183	530 Count	595 Count	393 Count
1757871279	527 Count	592 Count	391 Count
1757870376	525 Count	590 Count	390 Count
1757869472	522 Count	587 Count	388 Count
1757868568	519 Count	584 Count	386 Count
1757867664	516 Count	580 Count	384 Count
1757866761	513 Count	576 Count	382 Count
1757865857	511 Count	573 Count	381 Count
1757864953	509 Count	572 Count	380 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)