EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1769521653	149 Count	270 Count	95 Count
1769520750	147 Count	268 Count	94 Count
1769519846	145 Count	265 Count	93 Count
1769518942	143 Count	259 Count	92 Count
1769518039	141 Count	254 Count	91 Count
1769517135	139 Count	250 Count	90 Count
1769516231	137 Count	246 Count	89 Count
1769515327	135 Count	241 Count	88 Count
1769514423	133 Count	237 Count	87 Count
1769513519	131 Count	235 Count	86 Count
1769512615	129 Count	233 Count	85 Count
1769511712	127 Count	229 Count	84 Count
1769510808	125 Count	226 Count	83 Count
1769509997	123 Count	219 Count	82 Count
1769509093	121 Count	215 Count	81 Count
1769508190	119 Count	212 Count	80 Count
1769507286	117 Count	209 Count	79 Count
1769506382	115 Count	205 Count	78 Count
1769505478	113 Count	203 Count	77 Count
1769504574	111 Count	200 Count	76 Count
1769503670	109 Count	197 Count	75 Count
1769502767	107 Count	194 Count	74 Count
1769501863	105 Count	190 Count	73 Count
1769500959	103 Count	186 Count	72 Count
1769500056	101 Count	183 Count	71 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)