EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1792920528	32 Count	669 Count
1792919628	26 Count	620 Count
1792918727	24 Count	567 Count
1792917901	18 Count	531 Count
1792917000	16 Count	472 Count
1792916099	12 Count	402 Count
1792915198	10 Count	344 Count
1792914298	7 Count	292 Count
1792913397	5 Count	233 Count
1792912496	1 Count	137 Count
1792911595	31 Count	1127 Count
1792910695	28 Count	993 Count
1792909794	26 Count	906 Count
1792908893	23 Count	832 Count
1792907992	21 Count	756 Count
1792907092	18 Count	678 Count
1792906191	16 Count	590 Count
1792905290	13 Count	467 Count
1792904389	12 Count	347 Count
1792903489	9 Count	269 Count
1792902588	7 Count	184 Count
1792901687	4 Count	122 Count
1792900786	2 Count	57 Count
1792899886	32 Count	1046 Count
1792898985	31 Count	970 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)