EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1754124314	400 Count	383 Count	39 Count
1754123506	398 Count	383 Count	39 Count
1754122605	396 Count	383 Count	39 Count
1754121704	394 Count	383 Count	39 Count
1754120803	379 Count	370 Count	26 Count
1754119902	376 Count	369 Count	25 Count
1754119001	373 Count	368 Count	24 Count
1754118100	371 Count	368 Count	24 Count
1754117199	369 Count	368 Count	24 Count
1754116297	367 Count	368 Count	24 Count
1754115396	365 Count	364 Count	24 Count
1754114494	363 Count	363 Count	24 Count
1754113593	361 Count	362 Count	24 Count
1754112692	359 Count	359 Count	24 Count
1754111791	357 Count	356 Count	24 Count
1754110891	355 Count	355 Count	24 Count
1754109990	353 Count	355 Count	24 Count
1754109088	351 Count	355 Count	24 Count
1754108187	349 Count	355 Count	24 Count
1754107287	347 Count	355 Count	24 Count
1754106385	345 Count	355 Count	24 Count
1754105485	343 Count	355 Count	24 Count
1754104584	341 Count	355 Count	24 Count
1754103683	338 Count	355 Count	24 Count
1754102782	336 Count	355 Count	24 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)