EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757096460	89 Count	173 Count
1757095854	87 Count	169 Count
1757095250	85 Count	165 Count
1757094643	83 Count	161 Count
1757094037	81 Count	157 Count
1757093431	79 Count	153 Count
1757092825	77 Count	149 Count
1757092219	75 Count	145 Count
1757091614	73 Count	141 Count
1757091009	71 Count	137 Count
1757090402	69 Count	133 Count
1757089796	67 Count	129 Count
1757089190	65 Count	125 Count
1757088584	63 Count	121 Count
1757087978	61 Count	117 Count
1757087373	59 Count	113 Count
1757086767	57 Count	109 Count
1757086161	55 Count	105 Count
1757085555	53 Count	101 Count
1757084949	51 Count	97 Count
1757084344	49 Count	93 Count
1757083738	47 Count	89 Count
1757083132	45 Count	85 Count
1757082526	43 Count	81 Count
1757081920	41 Count	77 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)