EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OZ1MAS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OZ1MAS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1751685790	462 Count	187 Count	158 Count
1751684885	460 Count	186 Count	157 Count
1751683981	458 Count	185 Count	156 Count
1751683077	456 Count	184 Count	155 Count
1751682172	454 Count	183 Count	154 Count
1751681268	452 Count	182 Count	153 Count
1751680363	450 Count	181 Count	152 Count
1751679459	448 Count	180 Count	151 Count
1751678554	446 Count	179 Count	150 Count
1751677650	444 Count	178 Count	149 Count
1751676746	442 Count	177 Count	148 Count
1751675841	440 Count	176 Count	147 Count
1751675043	438 Count	175 Count	146 Count
1751674139	436 Count	174 Count	145 Count
1751673234	434 Count	173 Count	144 Count
1751672330	432 Count	172 Count	143 Count
1751671425	430 Count	171 Count	142 Count
1751670521	428 Count	170 Count	141 Count
1751669616	426 Count	169 Count	140 Count
1751668712	424 Count	168 Count	139 Count
1751667808	422 Count	167 Count	138 Count
1751666903	420 Count	166 Count	137 Count
1751665999	418 Count	165 Count	136 Count
1751665094	416 Count	164 Count	135 Count
1751664190	414 Count	163 Count	134 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)