EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

OZ1MAS-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OZ1MAS-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1751422060	917 Count	294 Count	282 Count
1751421156	913 Count	290 Count	279 Count
1751420251	912 Count	290 Count	279 Count
1751419346	909 Count	288 Count	277 Count
1751418442	903 Count	283 Count	272 Count
1751417537	898 Count	278 Count	268 Count
1751416633	893 Count	274 Count	264 Count
1751415835	889 Count	270 Count	261 Count
1751414930	881 Count	263 Count	254 Count
1751414025	877 Count	259 Count	251 Count
1751413121	876 Count	259 Count	251 Count
1751412216	874 Count	258 Count	250 Count
1751411312	873 Count	258 Count	250 Count
1751410408	871 Count	257 Count	249 Count
1751409503	870 Count	257 Count	249 Count
1751408599	868 Count	256 Count	248 Count
1751407694	867 Count	256 Count	248 Count
1751406790	865 Count	255 Count	247 Count
1751405885	864 Count	255 Count	247 Count
1751404981	862 Count	254 Count	246 Count
1751404076	861 Count	254 Count	246 Count
1751403172	859 Count	253 Count	245 Count
1751402267	858 Count	253 Count	245 Count
1751401363	856 Count	252 Count	244 Count
1751400459	855 Count	252 Count	244 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)