EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789235263	546 Count	749 Count	79 Count
1789234062	543 Count	745 Count	78 Count
1789233461	541 Count	742 Count	77 Count
1789232861	540 Count	741 Count	77 Count
1789232259	538 Count	738 Count	76 Count
1789231658	536 Count	735 Count	75 Count
1789231058	535 Count	734 Count	75 Count
1789230457	533 Count	731 Count	74 Count
1789229856	531 Count	728 Count	73 Count
1789229255	530 Count	727 Count	73 Count
1789228654	528 Count	724 Count	72 Count
1789227453	525 Count	720 Count	71 Count
1789226852	523 Count	717 Count	70 Count
1789226251	521 Count	715 Count	69 Count
1789225650	520 Count	714 Count	69 Count
1789225049	518 Count	712 Count	68 Count
1789224449	516 Count	711 Count	67 Count
1789223848	515 Count	710 Count	67 Count
1789222646	512 Count	706 Count	66 Count
1789222045	511 Count	705 Count	66 Count
1789221445	509 Count	703 Count	65 Count
1789220844	507 Count	700 Count	64 Count
1789220243	506 Count	699 Count	64 Count
1789219642	505 Count	698 Count	64 Count
1789219041	504 Count	697 Count	64 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)