EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1781196833	471 Count	696 Count	55 Count
1781195660	465 Count	694 Count	55 Count
1781192656	456 Count	678 Count	51 Count
1781188451	441 Count	642 Count	43 Count
1781186648	436 Count	637 Count	41 Count
1781185446	434 Count	635 Count	41 Count
1781184846	433 Count	634 Count	41 Count
1781183643	431 Count	632 Count	41 Count
1781182441	429 Count	630 Count	41 Count
1781181841	428 Count	629 Count	41 Count
1781178837	423 Count	624 Count	41 Count
1781177635	421 Count	622 Count	41 Count
1781175232	417 Count	618 Count	41 Count
1781172665	408 Count	610 Count	41 Count
1781172064	407 Count	609 Count	41 Count
1781170862	405 Count	607 Count	41 Count
1781169660	403 Count	605 Count	41 Count
1781169060	402 Count	604 Count	41 Count
1781168352	400 Count	603 Count	41 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)