EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766640990	950 Count	37 Count	16 Count
1766640089	949 Count	37 Count	16 Count
1766639212	948 Count	37 Count	16 Count
1766638311	947 Count	37 Count	16 Count
1766637410	946 Count	37 Count	16 Count
1766636509	945 Count	37 Count	16 Count
1766635608	944 Count	36 Count	16 Count
1766634707	943 Count	35 Count	16 Count
1766633806	942 Count	34 Count	16 Count
1766632905	941 Count	33 Count	16 Count
1766632004	940 Count	32 Count	16 Count
1766631103	939 Count	32 Count	16 Count
1766630202	938 Count	32 Count	16 Count
1766629301	937 Count	31 Count	16 Count
1766628400	936 Count	31 Count	16 Count
1766627499	935 Count	30 Count	16 Count
1766626598	934 Count	29 Count	16 Count
1766625697	933 Count	29 Count	16 Count
1766624796	932 Count	29 Count	16 Count
1766623895	931 Count	28 Count	16 Count
1766622994	930 Count	28 Count	16 Count
1766622093	929 Count	28 Count	16 Count
1766621192	928 Count	27 Count	16 Count
1766620291	927 Count	26 Count	16 Count
1766619390	926 Count	26 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)