EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1762421117	202 Count	452 Count
1762419317	201 Count	452 Count
1762417516	200 Count	451 Count
1762415717	199 Count	450 Count
1762413916	198 Count	448 Count
1762412115	197 Count	446 Count
1762410313	196 Count	445 Count
1762408520	191 Count	442 Count
1762406718	190 Count	440 Count
1762404918	189 Count	438 Count
1762403118	188 Count	435 Count
1762401317	187 Count	433 Count
1762399517	186 Count	431 Count
1762397716	185 Count	429 Count
1762395915	184 Count	428 Count
1762394114	183 Count	426 Count
1762392314	182 Count	423 Count
1762390514	181 Count	421 Count
1762386919	175 Count	415 Count
1762385119	174 Count	409 Count
1762383317	173 Count	408 Count
1762379715	171 Count	402 Count
1762377915	170 Count	401 Count
1762376114	169 Count	401 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)