EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1760833434	46 Count	74 Count
1760831639	41 Count	70 Count
1760829840	40 Count	67 Count
1760828038	39 Count	65 Count
1760826238	38 Count	62 Count
1760824437	37 Count	60 Count
1760822636	36 Count	57 Count
1760820836	35 Count	55 Count
1760819035	34 Count	52 Count
1760817234	33 Count	50 Count
1760815434	32 Count	47 Count
1760813633	31 Count	45 Count
1760811833	30 Count	42 Count
1760810037	25 Count	38 Count
1760806436	23 Count	33 Count
1760804635	22 Count	31 Count
1760802835	21 Count	29 Count
1760801034	20 Count	26 Count
1760799234	19 Count	24 Count
1760797433	18 Count	22 Count
1760795632	17 Count	20 Count
1760793832	16 Count	18 Count
1760792031	15 Count	16 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 1, 0

V_Ext: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)