EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1789223695	56 Count	648 Count
1789222795	55 Count	639 Count
1789221901	54 Count	629 Count
1789220993	53 Count	618 Count
1789220092	52 Count	610 Count
1789219192	51 Count	603 Count
1789218291	50 Count	594 Count
1789217390	49 Count	587 Count
1789216490	48 Count	576 Count
1789215589	47 Count	564 Count
1789214688	46 Count	551 Count
1789213787	45 Count	548 Count
1789212887	44 Count	545 Count
1789212002	43 Count	538 Count
1789211101	42 Count	530 Count
1789210200	41 Count	523 Count
1789209299	40 Count	518 Count
1789208399	39 Count	518 Count
1789207498	38 Count	518 Count
1789206597	37 Count	513 Count
1789205697	36 Count	504 Count
1789204796	35 Count	496 Count
1789203895	34 Count	489 Count
1789202994	33 Count	479 Count
1789202094	32 Count	467 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)