EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1785288459	51 Count	640 Count
1785287558	50 Count	626 Count
1785286658	49 Count	610 Count
1785285757	48 Count	596 Count
1785284856	47 Count	580 Count
1785283955	46 Count	569 Count
1785283055	45 Count	558 Count
1785282154	44 Count	547 Count
1785281253	43 Count	536 Count
1785280353	42 Count	525 Count
1785279452	41 Count	514 Count
1785278551	40 Count	503 Count
1785277650	39 Count	492 Count
1785276750	38 Count	481 Count
1785275849	37 Count	470 Count
1785274948	36 Count	460 Count
1785274048	35 Count	450 Count
1785273147	34 Count	441 Count
1785272246	33 Count	430 Count
1785271346	32 Count	419 Count
1785270445	31 Count	408 Count
1785269544	30 Count	398 Count
1785268643	29 Count	388 Count
1785267738	28 Count	377 Count
1785266855	27 Count	366 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)