EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9RUT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9RUT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758153035	474 Count	99 Count
1758151240	447 Count	88 Count
1758149486	414 Count	80 Count
1758147678	386 Count	71 Count
1758145877	355 Count	64 Count
1758144077	327 Count	55 Count
1758142275	297 Count	49 Count
1758140458	268 Count	42 Count
1758138662	237 Count	35 Count
1758136844	208 Count	27 Count
1758124219	1008 Count	247 Count
1758120604	948 Count	235 Count
1758115204	860 Count	233 Count
1758111599	801 Count	229 Count
1758102599	649 Count	204 Count
1758100798	621 Count	198 Count
1758091793	473 Count	168 Count
1758089994	446 Count	161 Count
1758086390	388 Count	142 Count
1758084564	354 Count	130 Count
1758082764	327 Count	122 Count
1758080964	296 Count	111 Count
1758079164	268 Count	101 Count
1758077364	237 Count	90 Count
1758075559	210 Count	79 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)