EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

WD4ITE-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WD4ITE-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753140653	672 Count	210 Count	210 Count
1753140053	671 Count	210 Count	210 Count
1753139452	668 Count	208 Count	208 Count
1753138851	666 Count	207 Count	207 Count
1753138251	665 Count	207 Count	207 Count
1753137650	663 Count	206 Count	206 Count
1753137049	661 Count	205 Count	205 Count
1753136448	660 Count	205 Count	205 Count
1753135847	658 Count	204 Count	204 Count
1753135246	656 Count	203 Count	203 Count
1753134646	655 Count	203 Count	203 Count
1753134045	653 Count	202 Count	202 Count
1753133444	651 Count	201 Count	201 Count
1753132844	650 Count	201 Count	201 Count
1753132243	648 Count	200 Count	200 Count
1753131642	646 Count	199 Count	199 Count
1753131331	645 Count	199 Count	199 Count
1753130441	643 Count	198 Count	198 Count
1753129839	641 Count	197 Count	197 Count
1753129239	640 Count	197 Count	197 Count
1753128638	638 Count	196 Count	196 Count
1753128037	636 Count	195 Count	195 Count
1753127436	635 Count	195 Count	195 Count
1753126865	633 Count	194 Count	194 Count
1753126264	631 Count	193 Count	193 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)