EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1757928505	23 Count	152 Count
1757924947	9 Count	66 Count
1757921338	28 Count	1029 Count
1757917730	26 Count	973 Count
1757914121	24 Count	911 Count
1757910513	22 Count	826 Count
1757906905	20 Count	763 Count
1757903345	18 Count	702 Count
1757899736	16 Count	636 Count
1757896128	14 Count	542 Count
1757892520	12 Count	470 Count
1757888912	10 Count	408 Count
1757885303	8 Count	341 Count
1757881745	6 Count	279 Count
1757878137	4 Count	158 Count
1757874529	2 Count	82 Count
1757870921	28 Count	1001 Count
1757867312	26 Count	929 Count
1757863703	24 Count	851 Count
1757860145	22 Count	779 Count
1757856537	20 Count	711 Count
1757852929	18 Count	648 Count
1757849321	16 Count	578 Count
1757845713	14 Count	498 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)