EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1764957282	2 Count	17 Count
1764955474	0 Count	0 Count
1764949863	43 Count	996 Count
1764948155	41 Count	949 Count
1764946347	39 Count	904 Count
1764944538	37 Count	851 Count
1764942730	35 Count	798 Count
1764940921	33 Count	740 Count
1764939113	31 Count	687 Count
1764937304	29 Count	637 Count
1764935496	27 Count	582 Count
1764933687	25 Count	514 Count
1764931878	23 Count	447 Count
1764930069	21 Count	393 Count
1764928260	19 Count	344 Count
1764926555	17 Count	293 Count
1764924746	15 Count	240 Count
1764922938	13 Count	187 Count
1764921130	11 Count	139 Count
1764919321	9 Count	108 Count
1764917513	7 Count	89 Count
1764915704	5 Count	68 Count
1764913895	3 Count	49 Count
1764912086	1 Count	25 Count
1764910279	66 Count	1001 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)