EA2RCF LoRa APRS MAP

My position About Go to BACKUP map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IJY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1752923256	267 Count	419 Count	233 Count
1752922350	261 Count	403 Count	228 Count
1752921445	252 Count	386 Count	220 Count
1752920540	243 Count	368 Count	212 Count
1752919635	236 Count	350 Count	206 Count
1752918730	228 Count	336 Count	199 Count
1752917946	221 Count	327 Count	193 Count
1752917041	214 Count	314 Count	187 Count
1752916136	207 Count	299 Count	181 Count
1752915231	198 Count	283 Count	173 Count
1752914326	190 Count	265 Count	166 Count
1752913421	183 Count	251 Count	160 Count
1752912516	176 Count	238 Count	154 Count
1752911611	166 Count	223 Count	145 Count
1752910705	157 Count	213 Count	137 Count
1752909800	150 Count	202 Count	131 Count
1752908895	143 Count	191 Count	125 Count
1752907990	136 Count	178 Count	119 Count
1752907085	129 Count	164 Count	113 Count
1752906180	121 Count	150 Count	106 Count
1752905275	115 Count	137 Count	101 Count
1752904370	107 Count	128 Count	94 Count
1752903465	99 Count	118 Count	87 Count
1752902560	90 Count	108 Count	79 Count
1752901655	84 Count	101 Count	74 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)