EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1773727668	2 Count	410 Count
1773725867	1 Count	233 Count
1773724066	7 Count	1152 Count
1773722265	6 Count	968 Count
1773720464	5 Count	778 Count
1773718664	3 Count	581 Count
1773716863	2 Count	393 Count
1773715071	0 Count	212 Count
1773713270	6 Count	1042 Count
1773711470	4 Count	838 Count
1773709669	3 Count	577 Count
1773707868	2 Count	389 Count
1773706067	0 Count	188 Count
1773704266	8 Count	1143 Count
1773702466	5 Count	963 Count
1773700665	4 Count	772 Count
1773698864	2 Count	571 Count
1773697063	1 Count	389 Count
1773695263	0 Count	172 Count
1773693471	7 Count	1063 Count
1773691670	6 Count	897 Count
1773689869	3 Count	721 Count
1773688069	2 Count	475 Count
1773686267	0 Count	203 Count
1773684467	6 Count	1054 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)